Hanyoung TH500 Manual page 53

5.2.7 Program pattern name setting
[Fig.65] Program pattern name screen
When pressing pattern name in the Program Pattern Name setting screen [Fig.65], Number Input
Screen[Fig.66] will be shown. When pressing
Program setup menu screen will be shown. Pressing
screen. When pressing the Program pattern name you want by means of right-upper side
button, Number input screen[Fig.66] will be shown. Enter the desired pattern number by
button.
5.2.8 Pattern/Segment management
[Fig.67] is the display for managing patterns through pattern copy, segment copy and segment
initializing. In the left side you should enter the source pattern or segment number used for pattern
management. In the right side you should enter the target pattern number of segment number to be
copied. After entering a desired value, you can copy it
by pressing
button on the left center is used for
initializing all the internal segments of the pattern
entered into the input box above. Pressing
it will be copied to contents related with every
segment in internal pattern. Pressing [Fig.67] Segment
management
the original start/End segment copy from a copy start
segment. It is possible to copy segment into your
desired position by inserting different segment numbers of the right copy when copying segment.
(Example : the original 1~6 to the copy 7~12)
, button in arrow.
button, it will copy contents of
[Fig.66] Number input screen
button in the function setting menu,
leads to Program pattern name
,
[Fig.67] Pattern/Segment management
54