Hanyoung TH500 Manual page 52

5.2.6 Pattern start mode setting
The initial setting value is necessary to ascent or descent by the setting value of 1st segment when
you start to work with Program control. Select this the initial setting value between Start setting
value(S.SV) and Current measurement value(S.PV). Pressing
Program setting menu display, Pattern alarm setting display will be shown. Pressing
again In this display, it will be shown to [Fig.61] S.PV Working start setting display.
[Fig.61] S.PV Operaiton start setting display
Name
Enter the pattern number to set or select it by pressing
PTN NO.
the
Start the operation based on the SV set in the
START S.SV
temperature & humidity S.SV below.
MODE
S.PV Start the operation based on the current
Set to the start SV upon temperature program running.
T. S.SV
Set to the start SV upon humidity program running.
H. S.SV
Start program operation
[FIG.63] S.SV Operation start mode
Function
/ button.
53
,
[Fig.62] S.SV Operation start setting display
(-100~200) ℃ (TH500)
(-100~500) ℃ (TH300)
Start program operation
S
[FIG.64] S.PV Operation start mode
buttons in
button
Range
1~100 Pattern
-
-
(0~100) %