Hanyoung TH500 Manual page 30

• When it comes to temperature, its PV will be always displayed unless the sensor
line is disconnected. However, as far as humidity is concerned, its PV will not be
indicated unless a setting value (SV) is entered. If you set the SV to 0 and press
the
• It is impossible to execute A/T for temperature and humidity at the same time.
Therefore, it is desirable to try tuning humidity while maintaining a target temperature.
The button concerned will turn on and off during tuning.
Auto Tuning button : When pressing
setting menu will be displayed. After pressing left-top button and pressing password, System Setup
screen will be displayed, Once again if you press [Sensor Input Setup], Sensor Input Setup screen 1
will be displayed. Press
Sensor Input Setup 4.
Temperature Auto Tuning button (Turn on and off during running)
Humidity Auto Tuning button (Turn on and off during running)
3.4.2 Running selection of Fix-control 2.
Process value and Set value of temperature and humidity is shown basically in the running screen 2
for fix control. There is shown also for Inner signal(I/S), Time signal(T/S), Digital input signal(D/I),
Alarm signal(A/S), and indicate a gradient of initial set value by form of UP/DN and SOAK.
[Fig.14] Running stopped screen 2 for Fix control.
※ Pressing the indicated circle in the [Fig.14] will change the display unit
button, you can control the temperature only.
button in the running screen of Fixing Control, function
button and Auto Tuning will be shown on A/T button indication in the
⇦ ➡
[Fig.15] Running screen 2 for Fix control
31