Hanyoung TH500 Manual page 50

SEG progress without
applying standby mode
SEG progress with
applying standby mode
[FIG.58] Standby action cancellation due to the elapse of standby time
5.2.5 Pattern Alarm Setting
Within the function setting menu [FIG 44] screen, press
to enter into the standby operation setting [FIG 56] screen. After that, press the
to enter into the pattern alarm setting [FIG 59] screen.
[FIG.59] Pattern alarm setup screen
S
a
a
Set
standby time
Standby
operation
Standby operation starts
to on because PV did not fall
within the standby range
S
O
w
51
standby range
Start the standby operation
because PV did not fall within
the set standby range Cancel the
standby operation even though PV
did not fall within the set standby range
because standby time is elapsed.
b
[FIG.60] Alarm code selection
buttons
button