Hanyoung TH500 Manual page 77

D.O Configuration Setting 4,5[Fig.115 & Fig116] is screens that functions such as alarm are
allocated to real relay output and open collector output.
Setting item
S.Alarm 1~ 4
P.Alarm 1~ 4
Setting item
T.RUN
H.RUN
RUN/STOP
WAIT
HOLD
Sensor Burnout
6.7.5 D.O Configuration Setting 6
Setting item
In case of D.I input, its output becomes ON for a setting time. IF RUN/STOP, STEP
D.I ERROR (sec)
and HOLD function input is set, its D.I will be not included.
NORMAL END(sec) Once program control ends, its output becomes ON for a setting time
After doing output of I.S(Inner Signal)#1,its output becomes ON after delaying for a setting time.
DELAY Sig.1 (sec)
After doing output of I.S(Inner Signal)#1,its output becomes ON after delaying for a setting time.
DELAY Sig. 2(min)
(Delay signal 2 is only available in the middle of performing Delay signal 1
When selecting Humidity Set Value (H.SV) as "0" : stop controlling humidity, relevant
DRAIN Signal (min)
output will be on during set time.
Assign System Alarm Output 1 ~ 4
Assign Pattern Alarm Output 1 ~ 4
Output assignment when controlling temperature
Output assignment when controlling humidity
Output assignment under RUN/STOP
Output assignment for WAIT operation
Output assignment for HOLD operation
Output assignment in case of sensor disconnection
[FIG.117] D.O Configuration Setting 6
Explanation
Explanation
Explanation
78