Hanyoung TH500 Manual page 56

⦁ [table 4] Selection of storage condition
Button
USB selection
As far as the saving operations are concerned, the total 86,400 pieces of information on temperature
& humidity (Y/M/D, temperature & humidity SV/PV/MV) under current controlling will be recorded to
the internal memory. The saving cycle can be designated as 1 to 360 seconds. Therefore, if the
saving cycle is 1 second, it can save for one day. On the other hand, if the saving cycle is
30 seconds, it can save for 30 days. Also recorded data will be stored in accordance with table
4 : Selection of storage condition.
When selecting
USB MEMORY STICK with our product name "EM310(Sold separately).
● Data transmission by USB connector
TH500 present USB connection function to send saved data to PC. According to Save Sequence &
Save Operation Mode set in [Fig.70] Graph Setting display, Data stored in internal memory become
mass difficult to transfer with low-speedy connection (max 115,200 BPS) interface like RS232,
RS422/485. If you send by using USB connection in that time, it is possible to send to PC within a
few second.
[Fig.72] is the display of USB Up-loader software presented by HANYOUNG NUX CO., LTD. When
USB connecter is connected, Device connecting status is indicated, "Connected" in blue and
button is activated. Pressing Send button, you can receive every Measure/control
Name
ALWAYS ON
Save always.
Save during controlling only.(Fix/Program)
RUN ON
FIX-RUN ON Save during fixed-mode controlling only.
Program-
save during program mode controlling only.
RUN ON
Internal Buffer
Delete/Initialize Saved Contents in internal memory
initialize
USB
Do not use USB MEMORY STICK.
cancellation
Record on USB MEMORY STICK.
, it will be recorded on USB MEMORY STICK. But it requires to connect
Function
57