Type-S Trolley Disassembly
Power Supply
Removal
4-8
Maintenance: Disassembly Guidelines
To dismount the MAC 5000 from the Type-S trolley, follow the steps
shown in the illustration below.
NOTE
A #10 TORX driver is required for disassembly and assembly of the
power supply.
1. Turn the unit over so the bottom side is up.
2. Using a #10 TORX driver, remove the three screws holding the power
supply in place.
3. Lift the power supply to expose the wiring harness and ground wire.
MAC™ 5000 resting ECG analysis system
2024917-010
39A
Revision B