Read Barcode On/Off; Decode Central Area; Image Flipping - Newland NLS-NVH200 User Manual

Read Barcode On/Off
Through sending the command can control to enable or disable to scan the barcode. By default, read barcode is enabled.

Read Barcode Off: Sending the Read Barcode Off command ~<SOH>0000#SCNENA0;<ETX> to the scanner can disable it from reading
barcode, and the scanner is unable to scan barcode unless you send the Read Barcode On command

Read Barcode On: Sending the command: ~<SOH>0000#SCNENA1;<ETX> to power cycle it.
Decode Central Area

Whole Area Decoding: The scanner attempts to decode barcode(s) within its field of view, from the center to the periphery,
and transmits the barcode that has been first decoded.

Aimed Barcode Decoding: The scanner only decodes the barcode aimed squarely by the aiming pattern. For those using a
crosshair aiming pattern, only the barcode aimed by the center of crosshair will be decoded.
** Whole Area Decoding
Image Flipping
it can supported to flip horizontally or Vertical mirror output, in addition, you can get the Image through the Easyset.
** Not Flipping
33 **Exit Setup
Enter Setup
Aimed Barcode Decoding
Flip Horizontally