Enter Setup
Add a Data Format
Format
Step 1: Scan the Enter Setup barcode.
Step 2:Scan the Add Data Format barcode.
Step 3: Select a label (Format_0 or Format_1 or Format_2 or Format_3).
Scan a numeric barcode 0 or 1 or 2 or 3 to label this data format Format_0 or Format_1 or Format_2 or Format_3.
Step 4: In turn, read the data code "6", "9", "9", "9".
Step 5: Select bar code serial number
The data format only works on the bar code of the specified type. Refer to appendix ‐ bar code serial number comparison table. The
bar code serial number consists of 3 data bits. If the data format is valid for all barcode types, the bar code serial number is set to
999. For example, only for EAN‐13 processing, then read the data code "005".
Step 6: Set Length Range for barcode
。The data format only works on the bar code of the specified length. The length of data consists of 4 data bits. For example, when
barcode data length is 32, then read the data code "0032". If the data format is valid for all data bar codes, the bar code length is
set to 9999.
Step 7:Set Formatter commands
Scan the data code to set the required data formatter command. For example, if the data formatter command is F141, then read
the data code "F141". The maximum length of the data formatter command is 500 characters. For detailed commands, please refer
to the data format edit command.
Step 8:Scan " Save" barcode.
**【Exit Setup】 188
Add Data Format