Read Barcode On/Off
Sending the Read Barcode Off command ~<SOH>0000#SCNENA0;<ETX> to the scanner can disable it from reading
barcode, and the scanner is unable to scan barcode unless you send the Read Barcode On command
~<SOH>0000#SCNENA1;<ETX> to it or power cycle it. By default, Read Barcode is On.
Transmit Not Good Read Message
Enable: When the code failed to decoded, and you release the trigger or Decode Session Timeout , Not Good Read
Message will be sent to the host.
Disable: When the code failed to decoded, Not Good Read Message will not be sent to the host.
@NGRENA0
** Disable
Edit NGR Message
Not Good Read Message supports up to 7 characters, from 0 to oxff. (Default: NG)
39
@NGRSET
Edit NGR Message
@NGRENA1
Enable