Newland NLS-NVH200 User Manual page 218

Enter Setup
Custom Prefix
If you have enabled the Custom Prefix, you are allowed to append to the data a user‐defined prefix.
For example, if the custom prefix is "AB" and the barcode data is "123", the Host will receive "AB123".
** Disable Custom Prefix
Modify Custom Prefix
To set a custom prefix, scan the Set Custom Prefix barcode then the numeric barcodes corresponding to the
hexadecimal value of a desired prefix then the Save barcode. Also A custom prefix cannot exceed 10 characters whose
range is 0x00~0xFF.
**【Exit Setup】 204
Set the custom prefix to "CODE" (HEX: 0x43/0x4F/0x44/0x45):
1. Scan the Enter Setup barcode.
2. Scan the Modify Custom Prefix barcode.
3. Scan the numeric barcodes "4", "3", "4", "F", "4", "4", "4" and "5" from the "Digit Barcodes" section
in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Enable Custom Prefix barcode.
6. Scan the Exit Setup barcode.
Modify Custom Prefix
Enable Custom Prefix