Enter Setup
Delete one data format: Scan the Clear One barcode, a numeric barcode (0‐3) and the Save barcode. For example, to delete
Format_2, you should scan the Clear One barcode, the 2 barcode and the Save barcode
Delete all data formats: Scan the Clear All barcode.
Delete one data format
Enable Data Format
After enabling the Data Formatter, you may select a data format you want to use by scanning the appropriate barcode below.
Default: Data Format 0
** Data Format 0
Data Format 2
Change Data Format for a Single Scan
You can switch between data formats for a single scan. The next barcode is scanned using the data format selected here, then
reverts to the format you have selected above. For example, you may have set your scanner to the data format you saved as Format
3. You can switch to Format 1 for a single trigger pull by scanning the Single Scan – Format 1 barcode below. The next barcode that is
scanned uses Format 1, then reverts back to Format 3.
**【Exit Setup】 190
Delete all data formats
Data Format 1
Data Format 3