Intended Use; Target Group; Service - Festo CPX-FB14 Electronic Manual

Contents and general instructions

Intended use

Target group

Service

Festo P.BE−CPX−FB14−E N en 0810b
The field bus node type CPX−FB14 described in this manual
has been designed exclusively for use as a slave on the
CANopen field bus.
The CPX terminal must only be used as follows:
as intended
in original condition
without unauthorised modifications
In faultless technical condition.
The limit values specified for pressures, temperatures,
electrical data, torques etc. should be observed.
Please comply with the regulations of the workers'
compensation insurance association, the German Technical
Control Board (TÜV) and the electrical requirements of the
VDE or the corresponding national and local safety
regulations.
This manual is intended exclusively for technicians trained in
control and automation technology who have experience in
installing, commissioning, programming and diagnosing
slaves on the CANopen field bus.
Please consult your local Festo repair service if you have any
technical problems.
VII