Password Setup - ABB CL Series Applications Manual

CL settings
ENTER PASSW
ENTER PASSW
196
h A password that has been entered in the logic relay is
transferred to the memory module together with the
circuit diagram, irrespective of whether it was activated or
not.
If this CL circuit diagram is loaded back from the memory
module, the password will also be transferred to the logic
relay and is activated immediately.

Password setup

A password can be set up via the system menu in either RUN
or STOP mode. You cannot change to the system menu if a
password is already activated.
Press DEL and ALT to call up the system menu.
X
Select the menu option SECURITY... to enter the
X
password.
Press the OK button and move to the PASSWORD...
X
menu.
Press OK again to enter the Password entry mode.
X
If no password has been entered, the logic relay changes
directly to the password display and displays four XXXX
âXXX
characters: No password present.
Press OK, four zeros will appear
X
Set the password using the cursor buttons:
X
ú í
–
ÍÚ
–
Save the new password by pressing OK.
X
Use OK to exit the password display and proceed with ESC
0042
Ú
and
The scope of the password has not yet been defined. The
password is now valid but not yet activated.
select position in the password,
set a value between 0 to 9.
to the RANGE... menu.
1SVC 440 795 M0100