1SVC 440 795 M0100
DEBOUNCE
P BUTTONS
RUN MODE
CARD MODE æ
Activating and
deactivating the P buttons
Activating debounce (input delay)
åÆ
å
A tick
next to
is activated.
If this is not so, proceed as follows:
DEBOUNCE
Select
X
Debounce mode will be activated and the display will show
DEBOUNCE å
Press ESC to return to the status display.
Deactivating debounce (input delay)
If the logic relay is showing
means that Debounce mode has already been deactivated.
Otherwise select
X
If Debounce mode is deactivated the display will show
DEBOUNCE
.
h
How the logic relay input and output signals are processed
internally is explained in section "Delay times for inputs
and outputs", from Page 230.
Even though the cursor buttons (P buttons) have been set as
pushbutton actuator inputs in the circuit diagram, this
function is not activated automatically. This prevents any
unauthorised use of the cursor buttons. The P buttons can be
activated in the system menu.
h
If the logic relay is password-protected you cannot open
the system menu until you have "unlocked" it.
h
Factory setting:
The P buttons are not activated.
Activating and deactivating
the P buttons
DEBOUNCE
indicates that this function
and press OK.
.
DEBOUNCE
DEBOUNCE å
and press OK.
in the display, this
215