ABB CL Series Applications Manual page 91

Wiring with the logic relay
88
Display in the logic relay:
• Markers M, N:
è:1
• Jumps:
h
Physical outputs should not be used as a cycle pulse is
generated.
Rising edge evaluation (cycle pulse)
This function is used if the coil is only meant to switch on a
rising edge. With a change in the coil state from 0 to 1, the
coil switches its n/o contacts to the 1 state for one cycle.
on
on
Figure 42: Signal diagram of cycle pulse with rising edge
Display in the logic relay:
• Markers M, N:
È:1
• Jumps:
h
Physical outputs should not be used as a cycle pulse is
generated.
èM1 èM16 èN1
to ,
è:8
to
ÈM1 ÈM16 ÈN1
to ,
È:8
to
1SVC 440 795 M0100
èN16
to
È
ÈN16
to