Startup Behaviour For Memory Module - ABB CL Series Applications Manual

1SVC 440 795 M0100
DEBOUNCE
P BUTTONS
RUN MODE
CARD MODEåæ

Startup behaviour for memory module

The startup behaviour using a memory module is for
applications where unskilled personnel have to change the
memory module with the logic relay de-energized.
The logic relay will then only start in RUN mode if a memory
module with a valid program is fitted.
If the program on the memory module is different to the
program in the logic relay, the program on the module is
loaded first and the logic relay starts in RUN mode.
h
Factory setting:
Card mode is not activated.
Switch to the system menu.
X
h
If the logic relay is protected by a password, the
system menu will not be available until the logic relay
is "unlocked" (a section "Unlock logic relay",
from Page 199).
Activate memory module startup
If the logic relay shows
will only start up in RUN mode at power on if the memory
module fitted contains a valid program.
Otherwise select
X
åÆ
The logic relay will start up with the program on the module.
å
Press ESC to return to the status display.
X
h Card mode is only possible with the CL-LAS.MD003
memory module. Old MD001 or MD002 memory modules
do not support this function.
Startup behaviour
RUN MODE å
CARD MODE
and press OK.
in the display, it
219