Blodgett Export Series Installation And Operation Manual page 16

Maintenance
Replacement of Parts
WARNING!!
Must be performed by an authorized service
agent only.
ELECTRICAL COMPONENTS
1. Turn off the main electrical connection to the oven.
2. Remove the components from the panel and set the
wiring aside.
3. Reinstall the components.
GAS CONTROL COMBINATION
NOTE: Gas models only.
1. Shut off the gas and turn off the power to the oven.
2. Remove the electrical connection.
3. Remove the gas connection in front of and behind the
control combination.
4. Remove the pilot line, replace, reinstall, and adjust.
Check for gas leaks.
Combustion
Cover
REMOVAL OF BURNER
NOTE: Gas models only.
1. Shut off the gas and turn off the power.
2. Remove the combustion cover.
3. Remove the gas connection, etc.
4. Remove the screws fromthe burner mounting bracket.
5. Remove the burner from the combustion chamber.
6. Replace pilot burner if necessary. Install the burner.
CONTROL COMPARTMENT COMPONENTS
1. Switch power off.
2. Remove the combustion cover.
3. Remove the control compartment cover.
4. Slide the control panel out.
5. Replace and repair the respective component.
6. Install the panel, the control compartment cover and
combustion cover.
DFG-100-ES Shown
Figure 14
14
Control Cover