Table of Contents
Advertisement
Installing the server and peripheral devices
To connect the modem to the server
You require a modem to support remote dial-up access to the Avaya CallPilot
modem, Avaya technical support can connect to your Avaya CallPilot server for troubleshooting
purposes. Avaya connects to your server only when you request technical assistance.
Windows automatically recognizes your modem after you connect it and power it on. The power
light (PWR LED) does not illuminate until the Windows device driver successfully loads and
recognizes the hardware.
To install the modem, you need the following equipment:
• USB modem
• RJ-11 analog phone cord
• USB cable (supplied with the modem)
• an analog line jack
Serial port modems with RS-232 connections are not supported on the 600r.
1. Connect one end of the USB cable into the modem.
2. Connect the other end of the USB cable into USB 2 on the rear panel.
3. Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.
4. Connect the other end of the telephone cable to the RJ-11 jack in the wall.
To connect the external SCSI tape drive
When you connect an external SCSI tape drive, the device must be terminated. Your tape drive
comes with a terminator. (See Tape drive terminator in
terminator
High Density Connection Interface) Ultra320 SCSI terminator. (See Server terminator in
8: SCSI tape drive with terminator
connect the server terminator to the SCSI port. Before you connect an external tape drive to
the 600r, you must remove the server terminator.
Note:
If you do not connect a SCSI device to the server, do not remove the server terminator from
the SCSI port.
32
Avaya CallPilot® 600r Server Hardware Installation
on page 33.) The 600r server also comes with a server terminator, a VHDCI (Very
Figure 8: SCSI tape drive with
on page 33.) In a previous procedure, you are instructed to
®
server. With a
Figure
December 2010
Advertisement
Table of Contents
