Replacing A Water Sensor - Huawei TP48200A-DT19D1 Telecom Power User Manual

TP48200A-DT19D1 Telecom Power
User Manual
Step 2 Remove the temperature sensor cable for the equipment compartment from the UIM, as
shown in Figure 4-24.
Figure 4-24 Removing the temperature sensor cable
Step 3 Cut off the cable tie of the sensor in the equipment compartment and remove it.
Figure 4-25 Position of the temperature sensor in the equipment compartment
Step 4 Properly place the new temperature sensor in the equipment compartment and bind it securely
with a cable tie.
Step 5 Reconnect the temperature sensor cable to the UIM.
Step 6 Disconnect the ground cable from the ESD wrist strap, and take off the ESD wrist strap and
ESD gloves.
----End

4.4.13 Replacing a Water Sensor

Prerequisites


Issue 03 (2019-11-15)
You have obtained an ESD wrist strap, a pair of ESD gloves, an ESD box or bag, the
cabinet door key, and tools.
The new water sensor is intact.
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
75