Replacing A Door Status Sensor - Huawei TP48200A-DT19D1 Telecom Power User Manual

TP48200A-DT19D1 Telecom Power
User Manual
Figure 4-27 Position of the water sensor
Step 4 Properly place the new water sensor and bind it securely with a cable tie, ensure that the
sensor is 5 mm to 10 mm away from the cabinet bottom.
Step 5 Reconnect the water sensor cable to the UIM.
Step 6 Disconnect the ground cable from the ESD wrist strap, and take off the ESD wrist strap and
ESD gloves.
----End

4.4.14 Replacing a Door Status Sensor

Prerequisites


Procedure
Step 1 Open the cabinet door and remove the shell of the door status sensor.
Step 2 Record the positions where the alarm cables connect to the door status sensor, and unscrew
the alarm cables.
Issue 03 (2019-11-15)
The cabinet door key and required tools are available.
The new door status sensor is intact.
Copyright © Huawei Technologies Co., Ltd.
4 Maintenance
77