Vx Ip Wizard Wizard Configuration Software For Videx Ip System - Videx IP videokit IPVK/6296 Series Installation Handbook

IPVK/6296 Series IP videokit
VX IP Wizard
Wizard configuration software for VIDEX IP System
DEVICE DETECTION & INITIALISATION
• Setup the network card connected to the system as explained in the preliminary network setup section.
• Run the "Videx IP Wizard.exe" with administrator rights from the folder where you have copied the software.
• If windows firewall is running, the first time that you launch the software you may receive a safety warning (Fig. 2): please allow
the "Videx IP Wizard.exe" to connect all types of network (local or public).
• On first time installation the software shows a notice (Fig. 3) that says that there are devices not initialised and requests confir-
mation to initialise them. The videophones show the "DEVICE NOT INITIALISED" screen (Fig. 4).
• Click on yes to automatically initialise all the devices connected to the system.
• The software initialises all the devices giving them a generic name and an IP address. Under settings->preferences you can
set the default prefix description for door panels and the default prefix description for the videophones. By factory default the
prefix for door panels is "DP__" and the prefix for videophones is "VP__". During the initialisation all devices will be automatically
assigned a device name that will be a combination of the prefix plus the device ID. Under settings->preferences the following
default values can also be assigned:
» The default start ID;
» The default first IP address
» The default subnet mask
» The default gateway
• The videophone goes into the "maintenance mode" showing the maintenance screen (Fig. 5).
• The wizard shows the devices detected (Fig. 6), the orange rows are outdoor panels while the yellow rows are indoor stations.
• On the device grid list you can edit directly the "Device ID", the "IP Address" and the "Device Description" (Fig. 7). Any change will
be uploaded immediately to the device.
As mentioned above, it is strongly recommended to name all devices with a descriptive name.
IPVK/6296 Series - Installation handbook
- 44 -
66550062-EN - V 1.1 - 31/05/18