Videx IP videokit IPVK/6296 Series Installation Handbook page 52

IPVK/6296 Series IP videokit
VX IP Wizard
Wizard configuration software for VIDEX IP System
UPDATE FIRMWARE OF A DEVICE
The firmware update of any device is simple thanks to the "update firmware" button available under the properties editing window
but must be carried out in safe conditions to avoid possible firmware corruption.
It is strongly advised to take the following precautions:
• If you are using a laptop to update device firmware, be sure that it is connected to the mains or the battery is fully charged.
• If the mains to which the device is connected is fluctuating, avoid making the update until this is resolved.
• Be sure that you are using the correct firmware update, door panel firmware cannot be used with videophone and viceversa.
If you are ok to proceed, to update the firmware of a device proceed as follows:
• Launch the Videx IP wizard, detect the Videx devices then click on edit properties button of the device to update (Fig. 26).
• Click the update firmware button (Fig. 27).
• Select the correct firmware file (Fig. 28).
• Confirm the update operation (Fig. 29).
• Wait until the firmware update (Fig. 30) terminates with the confirmation (Fig. 31)
Please note that the firmware update doesn't affect the device programming so when you update a door panel you don't need to program again the calling system like when you update an indoor
station it is not required to program again i.e. the "intercom address book".
IPVK/6296 Series - Installation handbook
- 52 -
66550062-EN - V 1.1 - 31/05/18