Videx IP videokit IPVK/6296 Series Installation Handbook page 43

IPVK/6296 Series IP videokit
VX IP WIZARD
VX IP WIZARD
Fig. 1
DESCRIPTION
The VX IP WIZARD is a configuration software for the VIDEX IP System and runs on Ms Windows 7 or higher operating systems.
The software does not require any installation, copy it into a folder then, from that folder, run the "VIDEX IP WIZARD" with adminis-
trator rights (Fig. 1). While the VX IP WIZARD is running, it is required that any running firewall is disabled.
The system uses a specific network class address, before starting the configuration it is necessary to change the network card IP
address as described in the 'preliminary network setup' section.
For the system configuration it is strongly recommended to use a PC with two network cards, one connected to the VIDEX IP SYS-
TEM and one connected to a network that can access the web to be able to receive Online support (For example a laptop with an
Ethernet connection and a Wifi connection). web to receive online support.
The IP kits are configured to work out of the box. The wizard may be used to change these default settings.
SYSTEM CONFIGURATION
The system configuration consists of
• Device detection & initialisation.
• Outdoor panel settings
• Video intercom settings
• Edit Device Global Parameters
• Edit System Preferences
• Register the installation site on the Videx Cloud for use with the Videx Cloudnected client app
During the system configuration it is strongly recommended to give a descriptive name to each device & relay that that will identify
the device location and the relay function i.e.:
• "Main Entrance" can be the device description of the door panel at the front entrance.
• "Pedestrian Gate" can be the description for the relay that enables the pedestrian gate.
• "Vehicle Gate" can be the description for the relay that enables the vehicle gate.
• "Ground Floor" in an apartment system can be the description of the videophone installed on the ground floor.
• "First Floor" in an apartment system can be the description of the videophone installed at the first floor.
These names will be shown during the operation and will make it easier to configure, test and use the system.
It is strongly recommended to do the setup in two steps, first setup all the network and device names and a second step to setup
functionality.
The correct assignment of names to each device and service will simplify the system setup.
Note that according to the installation size and the network traffic of the system to which the devices are connected, may happen that some operations some functions may not be immediate. (i.e.
after a firmware update of a device, may be necessary some seconds before the device is recognized again by the Videx IP Wizard): In these cases please repeat the operation.
IPVK/6296 Series - Installation handbook
Wizard configuration software for VIDEX IP System
- 43 -
66550062-EN - V 1.1 - 31/05/18