Videx IP videokit IPVK/6296 Series Installation Handbook page 33

Videokit

Hide thumbs Also See for IP videokit IPVK/6296 Series:

IPVK/6296 Series IP videokit

Windows

setup static IP address

Fig. 4 Edit network card properties

Under "Ethernet Properties" slide down to find "In-

ternet Protocol Version 4 (TCP/IPv4)", click on it then

click on the "Properties" button.

Set IP address and subnet mask

Fig. 6

IPVK/6296 Series - Installation handbook

Fig. 5 Select "Internet Protocol Version 4 (TCP/IPv4)"

- 33 -

Under "Network connection", right click on the net-

work card used for the LAN connection to the VIDEX

IP System then click on "Properties".

Under "Internet Protocol Version 4 (TCP/IPv4) Prop-

erties" click on the radio button "Use the following

IP address" then set the

IP Address "172.20.0.1",

Subnet mask "255.255.0.0"

and leave empty the other fields as shown in the

picture.

Click on "OK" button then close "Ethernet Properties".

Now the PC's network card is properly configured to

run the VIDEX IP wizard software.

66550062-EN - V 1.1 - 31/05/18

Table of Contents