Raycus RFL-C Series User Manual page 30

Wuhan Raycus Fiber Laser Technologies Co., Ltd.
User Guide 1000W/1200W/1500W Ver: 1.0
Interlock error, please power off the laser and check interlock
If „Laser emission is not disabled, please power off the laser and check if LASER button on the
front panel is pressed down‟ is present in the self-check process, please follow the instructions to
check the laser emission button on the front panel, press it to release, and then restart the product
with the key. Laser emission must be disabled on system start- up.
Checking RS-232 connection............................
RS-232 connected..........................................
System is doing self-check, please wait........
Interlock is ok................................................
Laser emission is not disabled, please power off the laser and check if LASER button on the
front panel is pressed down..........................
When „System has started, please wait..............‟ is presented, self-check is passed, „RDY‟
signal is sent, and error records will be presented, followed by an instruction to press „U‟ on the
keyboard in 3 seconds.
Err1 record: 0
->Module 1 T1 High temperature record: 0
->Module 1 T1 Low temperature record: 0
->Module 1 T2 High temperature record: 0
->Module 1 T2 Low temperature record: 0
->Module 1 T3 High temperature record: 0
->Module 1 T3 Low temperature record: 0
->Module 1 T4 High temperature record: 0
->Module 1 T4 Low temperature record: 0
->Module 2 T1 High temperature record: 0
28