Installation Instructions For Rim 8877/8878 - Assa Abloy Sargent Profile Series Installation Instructions Manual

Profile Series v.S1 PoE Exit Device
Installation for Profie Series v.S1 With 8877/8878 Rim Exit Device
8
Step #1 – Prepare Door
A. Verify Hand and Bevel of Door
• This device is non-handed.
• Door should be fitted and hung.
• Verify box label for size of exit device and function.
B. Door Preparation
If using a mullion, install prior to installing hardware.
Doors should be pre-prepped.
Prep door using the following (see website www.intelligentopenings.com):
• Exit installation instructions A6770
• Field Template A7992 (Wood)
• Door Manufacturer's Template 4640 (Metal and Wood)
Note: Wood door has additional cutout if installation includes a cylinder.
Step #2 - Position Exit Trim (ET)
For exterior applications, use ET gasket (52-0263) to seal
between ET escutcheon and outside door surface (Fig. 2A).
1A. For wood doors: Route ET wire harness through the
cylinder hole and out the other side (Fig. 2A).
1B. For metal doors: Route ET wire harness through the
cylinder hole and door.
2. Place ET trim on door.
3. Connector from ET harness connects
to connector from chassis (next step).
Left Hand
Reverse Bevel
LHRB
1
3
Showing Wood Door Template Without Cylinder Hole
1-800-810-WIRE • www.sargentlock.com • A7765C
Inside
Outside
Fig. 1A
Outside of Door
ET gasket
(part number
52-0263)
2
Fig. 2A
Right Hand
Reverse Bevel
RHRB
13