Assa Abloy Sargent Profile Series Installation Instructions Manual page 7

Profile Series v.S1 PoE Exit Device
Installation Wiring (Continued)
Door Position Switch
D
1. Prep door according to proper template (Fig. D1).
2. Insert connector end of DPS through the raceway on the latch edge of the door (Fig. D2).
3. Note: Only use collar when installing in a metal door.
4. To insert DPS, push wires through raceway toward lock prep.
5. Push DPS firmly into place by hand.
IMPORTANT: DO NOT TAP SWITCH WITH ANY TOOL.
6. To connect DPS to lock controller per diagram, refer to the wiring instruction sections in the
Installation Instructions section.
Dim 1
Dim 2
(See template)
Horizontal
of Strike
Frame
Door Position
Switch Hole
Vertical
of Strike
Strike for Cylindrical Lock
Fig. D1
Dim 1
Fig. D2
Inside of Door
Wood Frame Metal Frame
3/8" 3/4"
1-800-810-WIRE • www.sargentlock.com • A7765C
Inside of Door
Ground
Ring Terminal
Collar is used only
with metal doors.
4-Pin
From Hinge
Door Position
Switch (DPS)
7