Assa Abloy Sargent Profile Series Installation Instructions Manual page 22

Step #5 - Install Exit Chassis
1. Route ET harness through wire run channel for wood doors (Fig. 5A)
and through access hole for metal doors (not shown).
2. Mount exit chassis carefully. Do not pinch harness wires.
3. Position exit chassis on door with lever arm under
rear section of mortise lock (Fig. 5B).
4. Secure chassis and ET with (2) 1/4-20 x
2-3/8" flat head machine screws (Fig. 5C).
Fig. 5A
Step #6 - Install Cylinder
For devices without cylinders, skip this section.
1. Verify orientation of cylinder (Fig. 6A).
2. Slide cylinder through ET trim and thread into the lockbody,
rotating the cylinder clockwise.
Cylinder should rest flush on ET case.
3. Tighten the cylinder clamp screw using
#2 Phillips screwdriver to prevent the
cylinder from unscrewing (Fig. 6B).
4. Test cylinder function:
For 77 Function, that the key retracts latch.
22 1-800-810-WIRE • www.sargentlock.com • A7765C
Profile Series v.S1 PoE Exit Device
Ground
Ring
Terminal
Latchbolt
Unused
Fig. 5B
Outside of Door
Correct Incorrect
Fig. 6A
(4) #10 Wood or
#10-24 Machine
Screws
Chassis
Inside of Door
Lever
Lever arm
Fig. 6B
Fig. 5B
Cylinder
Clamp
Screw