Assa Abloy Sargent Profile Series Installation Instructions Manual page 20

Installation for Profie v.S1 With 8977/8978 Mortise Exit Device
9
Step #1 - Prepare Door
A. Verify Hand and Bevel of Door
• Check handing of door - this device is not
reversible
• Door should be fitted and hung
• Verify box label for size of exit device, func-
tion and handing
B. Door Preparation
Prep door using the following (available at www.intelligentopenings.com):
• Exit installation instructions A6705
• Field Template A7790
• Door Manufacturer's Template 4641 (Metal & Wood).
Note: Wood door has additional
cutout if installation includes a cylinder.
Step #2 - Install Mortise Lock
Slide mortise lock into door and securely fasten with (2) flat head screws (Fig. 2A).
Step #3 - Position Exit Trim
1. For exterior applications, use ET gasket (52-0263) to seal
between ET escutcheon and outside door surface (Fig. 3A).
2. Route ET harness through square wire cutout and out
other side of door.
3. Place ET control on door with spindle inserted
through mortise lock (Fig. 3A).
Outside of Door
20 1-800-810-WIRE • www.sargentlock.com • A7765C
Profile Series v.S1 PoE Exit Device
Inside
Left Hand
Reverse Bevel
Outside
LHRB
Fig. 1A
2
Fig. 3A
Showing Wood Door Template
Wood Door Template
With Cylinder
Fig. 2A
Right Hand
Reverse Bevel
RHRB
Outside of Door
1
ET gasket
(part number
52-0263)
3
Without Cylinder