Advertisement
Profile Series v.G1 Exit Device
6
Installation Instructions for Rim Type
Exit Device 8877/8878
IMPORTANT: BEFORE STARTING
• This device is non handed
• Door should be fitted and hung
• Verify box label for size of exit device, function and hand
Step #1 – Exit Hardware & Door Prep
1. If using a mullion, install in frame.
2. Prep door according to Exit installation instructions A6770 and template 4640 (metal and wood doors).
Step #2 – Installation of Outside Trim, Exit Chassis and Cylinder
A. Outside Trim
1. For exterior applications "ET" gasket (52-0263)
should be used to seal between "ET" escutcheon
and outside door surface
2. Route harness through under cut of cylinder hole
and out to other side of door
3. Place "ET" control onto door
Wire
ET Control
harness
Outside
of door
C. Cylinder Installation
NOTE: For devices without cylinder, go to Step D2.
1. Insert cylinder into "ET" control
2. Mate cylinder tailpiece into hub of exit device
chassis
3. Make sure "ET" harness is clear of cylinder and
cylinder tailpiece
6
800-810-WIRE (9473) • www.sargentlock.com • A7757C
ET gasket
#34
Cylinder
Outside
of door
Inside
Left Hand
Reverse Bevel
"LHRB"
Outside
B.Inside Trim
1. Route "ET" harness along track cutout for wood
doors and access hole for metal doors
2. Mount exit chassis carefully. DO NOT PINCH
HARNESS WIRES
3. "ET" spindle will engage into the hub of exit device
chassis
4. Secure chassis and "ET" with (2) 1/4 -20 x 2-3/8"
flat head machine screws
Wire harness
Inside
of door
(2) 1/4-20 x 2-3/8"
Flat head
machine screws
secures ET
D. Securing Cylinder
1. Secure cylinder to exit chassis using (2) #12-24 x
1-7/8" connecting screws
2. Fasten exit chassis to door using (4) #10 wood
screws or #10-24 machine screws
(4) #10 Wood
screws or #10-24
machine screws
(2) #12-24 x 1-7/8"
Flat head connecting
screws for cylinders
Right Hand
Reverse Bevel
"RHRB"
Exit Chassis
Inside
of door
Advertisement
