Rim Type 8877/8878 Exit Device Installation - Assa Abloy SARGENT IN220 Installation Instructions Manual

Installation Instructions for 8877/8878 Rim Exit
7
1 Door Preparation
A. Verify Hand and Bevel of Door
• Check hand of door.
The exit device is non-handed and
the trim is field reversible.
• Door should be fitted and hung.
B. Verify Product Label
C. Door Preparation
1. If mullion is used, install prior to installing hardware.
2. Doors should be pre-prepped (recommended).
3. Use appropriate templates:
• IN220 template A8214 (wood and metal)
• Exit installation instructions A6770
Note: Instruction examples show wood door installation.
For metal doors, route cables inside door.
Raceway for PoE
Through Bolt Holes
Cylinder Hole
Trim Lever Hole
ET Through Bolt Hole
1-800-810-WIRE • www.sargentlock.com • A8205B
Outside of Door
Through Bolt Holes
Door
Position
Switch
ET Through Bolt Hole
Fig. 1B
12
Inside
Left Hand
Reverse
LHR
Outside
Fig. 1A
Inside of Door
IN220 Exit Device
Right Hand
Reverse
RHR
Raceway
for PoE
Wire Run Channel
(Wood Door)
Cylinder Hole
Lever Hole
ET Through Bolt Hole