Installation Instructions - Assa Abloy Corbin Russwin IN120 Installation Instructions Manual

IN120 / IN220
FE6600/BL6600/MP6600 Series
Multi-point Lock

Installation Instructions

5 IN220 (PoE) Wiring & Installation (Continued)
Supplied by CI
Ceiling
24AWG
Stranded
Wire for
Ground in
15' Frame
Harness
Frame-
Harness
Assembly
(15' length)
drain wire
concealed
in shrink
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2019-2021 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
B-Splice
Crimp Connector
To building or electrical ground
RJ45-M RJ45-F Jack
Drain
Earth
Side
Cable
tubing
Molex-F Molex-F
Molex-M
A B
Certified Integrator (CI) supplies and terminates
the B-Splice connector and the
Male RJ45 connector from harness to
end user provided facility cable
Patch Panel to PoE
Cable: Cat5e or higher
24 AWG
NOTE: TIA/EIA 568-B added
only at lock side
D
Cable: Cat5e or higher,
PoE
26 AWG stranded,
Lock
shielded, 100ohm
RJ45-M
C
Molex-M
Ground
Ring Terminal
Secured to Lock
Mounting Plate
Wiring to EIA/TIA 568-B Standard
Supplied by End User
PoE Switch
Patch Cable
Switch
Patch Panel
Approved Software
Notes:
• Connectors go on only one way.
They cannot be placed in an
incorrect position.
• Do not force and do not
offset connectors
• Be sure they are completely
seated (flush).
• PoE power source cannot be
connected to a receptacle
controlled by a switch.
9
PoE Switch is
Terminated to
Earth Ground
FM455 04/21