Quick Start - Black Box 32144 Manual

This instruction manual applies
to the Modem 32144.
All information applies to both
the stand-alone and full-size rack-
mount versions of the modem.
Specialized low-profile rack-mount
versions, designed for use in high-
density rack enclosures, are
described in Appendix A.
QUICK SETUPS FOR A QUICK
START
The simplest and fastest way
to set up the modem for
immediate use is to select
one of the factory-preset
Quick Setup configurations.
For most applications, once
you have selected the proper
Quick Setup, the modem will
be ready for operation. You
will not need to make further
adjustments.Quick Setups
are explained fully beginning
in Section 2.3, following
installation instructions and a
brief introduction to the front
panel display and controls.
2.1 Installation
2.1.1 U
NPACKING
Keep the original shipping carton
in case you need to return the
modem for any reason.

2. Quick Start

CHAPTER 2: Quick Start
Note that if you ordered the
Modem 32144 Card, all you will
receive is the Card itself. It does not
come with the power transformer
or cables listed below.
If you ordered the Modem
32144, in addition to the modem,
the shipping carton should
contain—
• A power transformer
(with cable attached)
• A two-conductor crossover
cable with an eight-pin modular
connector on one end and a
six-pin modular connector on
the other end
• A four-conductor cable with two
six-pin modular connectors on
each end and spade lugs on the
other end
Two cables are supplied with
the modem, but both cables aren't
always needed, depending on the
application. You will need an EIA
RS-232 interface cable (not
supplied) to connect the modem to
the DTE (data terminal equipment,
usually a computer). If the modem
will be operated in a manual dial
mode, you will also need a standard
telephone set.
13