Configuration Level Of The Universal Indicator; General; Analog Inputs - C111 - JUMO 202550 Operating Instructions Manual

25 Configuration level of the universal indicator

25.1 General

Pre-
conditions

25.2 Analog inputs - C111

Not used
Analog input 1 (current signal)
0 — 20 mA
4 — 20 mA
Not used
Type of temperature acquisition
Manual temperature compensation
Automatic temperature compensation with Pt100
Automatic temperature compensation with Pt1000
72
The basic functions of the instrument can be displayed and/or altered at the
configuration level.
If it is necessary to reconfigure a number of instrument
parameters,
Chapter 35.1 "Programming the controller", page 103ff.
For an explanation of the terminology used,
Chapter 33 "Glossary", page 93ff.
How to configure controllers,
Chapter 27.1 "Configuration", page 83ff.
How to access the configuration level, or leave this level,
Chapter 9.2 "Principle of operation", page 24ff.
The configuration level is unlocked,
"Unlocking the levels", page 27, (code word 0300).
*The factory-set parameters are shown in the position boxes.
1
As a option, a Pt100 or Pt1000 can be connected. The measured
temperature of the process is then shown in the lower display. In this
mode, the temperature can be monitored with a limit comparator, see
also configuration codes C211 or 213.
C111* 1
1
1
a b c d
0 0 0
I I I I
0 I I I
I I I
I I I
0 I I
1 I I
I I
I I
0 I
I
I
0
1
2