Operator Level Of The Ph Indicator; Settings - JUMO 202550 Operating Instructions Manual

11.1 Settings

Pre-
conditions
Designation
Setpoint 1
Setpoint 2
Setpoint 3
Setpoint 4
Code word
Limit SP A (K1)
Limit SP b (K2)
Limit SP C (K3)
Limit SP d (K4)
Limit SP E (K5)
Temperature for
compensation
(manually
adjustable or
automatic,
depending on the
configuration)
Alarm tolerance
Alarm delay

11 Operator level of the pH indicator

How to access the operating level, or leave this level,
Chapter 9.2 "Principle of operation", page 24ff.
The operating level must be unlocked,
"Unlocking the levels", page 27, (code word 0110)
It is possible that not all of the following parameters are needed or
displayed, depending on the configuration of the controller
functions.
For an explanation of the terminology used,
Chapter 33 "Glossary", page 93ff.
How to configure controllers,
Chapter 27.1 "Configuration", page 83ff.
Parameter
Value range
(display)
SP(r)1
SP(r)2
-1.00 to 14.00 pH
SP(r)3
SP(r)4
CodE 4-digit
SP A
SP b
-1.00 to 14.00 pH
SP C or
-50 to 250°C
SP d
SP E
InP2 (°C)
AL1 0.00 to 99.99 pH
AL2 0 to 9999 sec
Factory displayed if ... is
setting configured
-1.00 K1
14.00 K2
-1.00
Setpoint changeover C112
14.00
0000
K1
K2
-1.00 K3
K4
K5
25
0
Controller alarm
messages
300
.
see
Configura-
tion
parameter
C211
C214
C113
C214
C111
C211 or
C213
33