6.1 Location
Conditions
Panel cut-out
for close
mounting
6.2 Fitting
The location should be as free from vibration as possible. Electromagnetic
fields, e. g. from motors, transformers etc. should be avoided. The ambient
temperature at the location can be from 0 to 50 °C, with a relative humidity of
not more than 75 %.
(1)
Fit the seal (1) that is supplied onto the body of the instrument.
Insert the controller from the front into the panel cut-out.
From behind the panel, slide the mounting brackets into the guides on the
sides of the housing. The flat faces of the mounting brackets must lie
against the housing.
Push the mounting brackets up to the back of the panel, and tighten them
evenly with a screwdriver.
6 Assembly
16