JUMO 202550 Operating Instructions Manual page 97

Term Parameter Explanation
Filter constant df
Hysteresis HYS
Limit controller C211
Logic input 1 / 2 C112
Make contact / C212
break contact
The setting of this parameter is used to filter out interference or
input signals which would provoke undesirable reaction in the
controller. The filter is a 2nd order digital filter.
Process value input
100
63
50
0
2 x df
see Switching differential
A single-setpoint controller with pull-in and / or drop-out delay.
see "Logic inputs", page 45.
Make contact: As long as the switching condition is fulfilled, the
corresponding output is active (closed).
Break contact: As long as the switching condition is not
fulfilled, the corresponding output is active (closed).
33 Glossary
filtered process value input
accepted by
controller as
process value input
t
Sampling time t
95