Appendix; Programming The Controller - JUMO 202550 Operating Instructions Manual

35 Appendix

35.1 Programming the controller

Configuration
Para- Explanation
meter
Configuration level
C111 Analog inputs
C112 Logic inputs / probe / supply
C113 Serial interface
C211 Controller options
C212 Controller outputs
C213 Other outputs I
C214 Other outputs II
C215 Response for HOLD / Overrange
C311 Process value output conductivity
SoL1 Scaling of the standard signal – start value K3
SoL2 Scaling of the standard signal – start value K5
SoH1 Scaling of the standard signal – end value K3
SoH2 Scaling of the standard signal – end value K5
SiL Start of transmission range
SiH End of transmission range
SPL Lower setpoint limit for controller setpoints – SP(r)1
SPH Upper setpoint limit for controller setpoints – SP(r)1
CELL Relative cell constant
ALPH Temperature coefficient
OFFS Process value correction for temperature
Parameter level
Pb1 Proportional band 1
Pb2 Proportional band 2
dt1 Derivative time 1
dt2 Derivative time 2
rt1 Reset time 1
rt2 Reset time 2
tr1 Minimum ON time 1
tr2 Minimum ON time 2
HYS1 Switching differential 1
103
If a number of instrument parameters have to be modified in the instrument,
then it is advisable to note them in the table below, and then modify these
parameters in the sequence given.
The following list shows the maximum number of parameters that
can be altered.
Depending on the type and configuration, your instrument may not
show some of the listed parameters.
Code words to unlock the individual levels,
"Unlocking the levels", page 27.
Factory New
setting setting
1000
0000
0100
1120
0010
8030
0011
0000
5000
0.00
0.00
1.00
1.00
0.00
1.00
0.00
1.00
100.0
2.30
0.0
0.50
0.50
0
0
0
0
0.2
0.2
0.30