Controller; Configuration - JUMO 202550 Operating Instructions Manual

27.1 Configuration

Possible
combinations
The controller functions are determined by the following parameters:
C211 C212
Controller off – –
Limit MIN / MAX

controller

contact
Pulse width MIN / MAX
controller contact
Pulse frequency MIN / MAX
controller contact
Modulating MIN / MAX
controller contact
Proportional MIN / MAX
controller contact
For an explanation of the terminology used,
Chapter 33 "Glossary", page 93ff.
The control functions of outputs 1 and 2 can be freely combined
- Controller off
- Limit controller
- Pulse width controller
- Pulse frequency controller
1
Exception: When using a modulating controller, outputs 1 and 2 must
have the same configuration.
1
Configuration level
C212
– –
make / break
contact
make / break
contact
make / break
contact
make / break
contact
make / break Proportional
contact controller 1
1
Chapter 26.4 "Controller options - C211", page 76 or
Chapter 26.5 "Controller outputs - C212", page 77 or
Chapter 26.6 "Other outputs I - C213", page 78 or
Chapter 26.7 "Other outputs II - C214", page 79.
2 Chapter 20 "Parameter level of the conductivity indicator", page 59ff.
3 Chapter 19 "Operator level of the conductivity indicator", page 58ff.
C213 C214
– – – –
– – – –
– – – –
– – – –
– – – –
Proportional
controller 2
27 Controller
1
:
2
Parameter level
– –
Switching differential HYS
Pull-in delay Ond
Drop-out delay Ofd
Proportional band Pb
Derivative time dt
Reset time rt
Minimum ON time tr
Pulse period CY
Output level limit Y1 or Y2
Proportional band Pb
Derivative time dt
Reset time rt
Minimum pulse width tr
Maximum pulse frequency Fr
Output level limit Y1 or Y2
Proportional band Pb
Derivative time dt
Reset time rt
Minimum ON time tr
Pulse period CY
Output level limit Y1 or Y2
Actuator time tt
Proportional band Pb
Derivative time dt
Reset time rt
Output level limit Y1 or Y2
3
Operating level
– –
Setpoint SP(r)
Setpoint SP(r)
Setpoint SP(r)
Setpoint SP(r)
Setpoint SP(r)
83