Parameter Level Of The Redox Indicator; Settings - JUMO 202550 Operating Instructions Manual

16 Parameter level of the redox indicator

16.1 Settings

Pre-
conditions
Parameter
Proportional band 1
Proportional band 2
Derivative time 1
Derivative time 2
Reset time 1
Reset time 2
Minimum ON
time 1 (for limit
controller or pulse
width controller) or
minimum pulse width 1
(for pulse frequency
controller)
Minimum ON
time 2 (for pulse width
controller) or
minimum pulse width 2
(for pulse frequency
controller)
44
If it is necessary to reconfigure a number of instrument
parameters,
Chapter 35.1 "Programming the controller", page 103ff.
How to access the parameter level, or leave this level,
Chapter 9.2 "Principle of operation", page 24ff.
The parameter level must be unlocked,
"Unlocking the levels", page 27, (code word 0020).
It is possible that not all of the following parameters are needed or
displayed, depending on the configuration of the controller
functions.
For an explanation of the terminology used,
Chapter 33 "Glossary", page 93ff.
How to configure controllers,
Chapter 27.1 "Configuration", page 83ff.
Display Value
range
Pb1
0001 to
9999 mV
Pb2
dt1
dt2
0 to
9999 sec
rt1
rt2
tr1
0.2 to
999.9 sec
tr2
Factory displayed if ... is configured
setting
Relay 1, pulse frequency or
pulse width
1000
Relay 2, pulse frequency or
pulse width
Relay 1, pulse frequency or
pulse width
Relay 2, pulse frequency or
pulse width
0
Relay 1, pulse frequency or
pulse width
Relay 2, pulse frequency or
pulse width
Controller 1, pulse width
pulse frequency
0.2
Relay 2, pulse width
pulse frequency
C211
C211
C211
C211
C211
C211
C211
C211
C211
C211