Graco Reactor 2 Series Operation page 11

Reactor 2 E-XP2i
All base systems include fluid inlet pressure and temperature sensors and Graco InSite
see Accessories, page
Model
Base Machine
Maximum Fluid Working Pressure psi
(MPa, bar)
Approximate Output per Cycle (A+B)
gal. (liter)
Max Flow Rate gal/min (l/min)
Total System Load † (Watts)
Voltage (phase)
Available Auxiliary Current at Volts, 60
Hz*
Fusion AP Package 
(Gun Part No.)
Probler P2 Package 
(Gun Part No.)
Heated Hose
50 ft (15 m)
Heated Whip Hose
10 ft (3 m)
Total system watts used by system, based on

maximum heated hose length of 310 ft (94.5 m)
for each unit.
* Full load amps available for auxiliary equipment
when all bare-system components are operating
at maximum capabilities. Available auxiliary
current is based on 310 ft (94.5 m) of heated hose.
An additional 3.0 amps (240 VAC) of auxiliary
current is available for each 50 ft (15.2 m) section
of heated hose that is not used.
Auxiliary current at 120 VAC is available on line 1
(circuit breaker pin 2), line 2 current at 120 VAC is
used by the air dryer (circuit breaker pin 4).
332636C
12.
No Air Compressor/Dryer
E-XP2i with heat
272081
3500 (24.1, 241)
0.0203 (0.0771)
2.0 (7.6)
11,600
240 VAC (1)
35 Amps (240)
AP2081
(246101)
P22081
(GCP2R1)
24Y241
246055
With Air Compressor/Dryer
E-XP2i with heat
272091
3500 (24.1, 241)
0.0203 (0.0771)
2.0 (7.6)
17,700
240 VAC (1)
5 Amps (240)
9 Amps (120)
AP2091
(246101)
P22091
(GCP2R1)
24Y241
246055
Available auxiliary current will be less when the

engine is de-rated for site altitude. Reduce the
Available Auxiliary Current in the chart by 2.5
Amps (240 VAC) per 1000 ft (300 m) elevation
increments. If the available auxiliary current is
less than zero, the system configuration may not
support the full load at that altitude.
Includes Complete Air Compressor/Dryer Kit

24U176.
Refer to Circuit Breaker Configuration Options,
page 33.
See Approvals, page

Packages include gun, heated hose, and whip

hose.
Models
. For part numbers,
™
12.
11