Dwell Time, G4 - Siemens SINUMERIK 840DE Programming Manual

Hide thumbs Also See for SINUMERIK 840DE:

Table of Contents

5.8 Dwell time, G4

Dwell time, G4

You can use G4 to interrupt workpiece machining between two NC blocks for the

programmed length of time, e.g., for relief cutting.

Programming in a separate NC block

The words with F... and S... are used for time specifications only in the block with G4.

Any previously programmed feed F and spindle speed S remain valid.

Activate dwell time, G4 interrupts the continuous-path mode

Time specified in seconds

Time specified in revolutions of the master spindle

Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1

Fundamentals

Show Quick Links

Table of Contents