Siemens SINUMERIK 840DE Programming Manual page 425

STARTFIFO Execute; simultaneously fill preprocessing
1
memory
STOPFIFO Stop machining; fill preprocessing memory
until STARTFIFO is detected, FIFO full or end
of program
SUPA Suppression of current zero offset, including
programmed offsets, system frames,
handwheel offsets (DRF), external zero offset
and overlaid motion
T Call tool
(only change if specified in
machine data; otherwise M6
command necessary)
TCARR Request toolholder (number "m")
TCOABS Determine tool length components from the
1
current tool orientation
TCOFR Determine tool length components from the
orientation of the active frame
TCOFRX Determine tool orientation of an active frame
on selection of tool, tool points in X direction
TCOFRY Determine tool orientation of an active frame
on selection of tool, tool points in Y direction
TCOFRZ Determine tool orientation of an active frame
on selection of tool, tool points in Z direction
TILT Tilt angle
5
TMOF Deselect tool monitoring
TMON Activate tool monitoring
TOFRAME Set current programmable frame to tool
coordinate system
TOFRAMEX X axis parallel to tool direction, secondary
axis Y, Z
TOFRAMEY Y axis parallel to tool direction, secondary
axis Z, X
TOFRAMEZ Z axis parallel to tool direction, secondary
axis X, Y
TOROTOF Frame rotations in tool direction OFF
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
1, ..., Call via
32 000 T No.: or via tool
identifier:
Integer m=0: deselect
active toolholder
Necessary after
reset, e.g.,
through manual
setting
Tool
perpendicular to
inclined surface
Tool
perpendicular to
inclined surface
Tool
perpendicular to
inclined surface
Real
T no. is only
necessary if the
tool with this
number is not
active.
T No. = 0:
Deactivate
monitoring for all
tools
Frame rotation
in tool direction
12.1 List of statements
e.g., T3 or T=3
e.g., T="DRILL"
TCARR=1
TMOF (T no.)
TMON (T no.)
Tables
m 4
m 4
s 9
m 42
m 42
m 42
m 42
m 42
m
m 53
m 53
m 53
m 53
m 53
12-19