Siemens SINUMERIK 840DE Programming Manual page 443

Group 26: Repositioning point for REPOS
Name No. Meaning
RMB 1. REPOS mode beginning of block: Reapproach to start of block position
RMI 2. REPOS – Mode interrupt: Reapproach to interruption point
RME 3. REPOS mode end of block: Repositioning to end-of-block position
RMN 4. REPOS mode end of nearest orbital block: Reapproach to nearest path
point
Group 27: Tool offset for change in orientation at outside corners
Name No. Meaning
ORIC # 1. Orientation change continuously: Orientation changes at outside corners
are superimposed on the circle block to be inserted
ORID # 2. Orientation change discontinuously: Orientation changes are performed
before the circle block
# The vocabulary word is not valid for SINUMERIK 810D/NCU571.
Group 28: Working area limitation ON/OFF
Name No. Meaning
WALIMON 1. Working area limitation ON: Working area limitation ON
WALIMOF 2. Working area limitation OFF: Working area limitation OFF
Group 29: Radius - diameter
Name No. Meaning
DIAMOF 1. Diametral programming OFF: Diameter programming OFF; radius
programming for G90/G91
DIAMON 2. Diametral programming ON: Diameter programming ON for G90/G91
DIAM90 3. Diametral programming G90: Diameter programming for G90; radius
programming for G91
DIAMCYCOF 4. Diametral programming OFF: Radius programming for G90/G91: ON.
The G-code of this group that was last active remains active for display
Group 30: Compressor ON/OFF
Name No. Meaning
COMPOF # 1. Compressor OFF
COMPON # 2. Compressor ON
COMPCURV 3. Compressor ON: Polynomials with constant curvature
#
COMPCAD # 4. Compressor ON: Optimized surface quality CAD program
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12.3 List of G functions/preparatory functions
X m/n
X m/n
X m/n
X m/n
X m/n
Tables
SAG MM
m
m Def.
m
m
SAG MM
m Def.
m
SAG MM
m Def.
m
SAG MM
m Def.
m
m
m
SAG MM
m Def.
m
m
m
12-37