Siemens SINUMERIK 840DE Programming Manual page 454

Tables
12.4 List of predefined subprograms
9. Grinding
Vocabulary 1st parameter
word/
subprogram
identifier
GWPSON INT: Spindle
number
GWPSOF INT: Spindle
number
TMON INT: Spindle
number
TMOF INT: T number
10. Stock removal
Vocabulary 1st parameter
word/
subprogram
identifier
CONTPRON REAL [ , 11]:
Contour table
CONTDCON REAL [ , 6]:
Contour table
EXECUTE INT: Error
status
12-48
Explanation
Grinding wheel peripheral speed ON: Constant grinding wheel peripheral speed ON
If the spindle number is not programmed, then grinding wheel peripheral speed is
selected for the spindle of the active tool.
Grinding wheel peripheral speed OFF. Constant grinding wheel peripheral speed
OFF.
If the spindle number is not programmed, grinding wheel peripheral speed is
deselected for the spindle of the active tool.
Tool monitoring ON:
If no T number is programmed, monitoring is activated for the active tool.
Tool monitoring OFF:
If no T number is programmed, monitoring is deactivated for the active tool.
2nd parameter 3rd
parameter
CHAR: Stock INT: Number
removal of relief cuts
method
"L":
Longitudinal
turning:
External
machining
"P": Face
turning:
External
machining
"N": Face
turning: Internal
machining:
"G":
Longitudinal
turning: Internal
machining
INT:
0: in
programmed
direction
4th Explanation
parameter
INT: Status Contour preparation on: Activate
of reference point editing
calculation: The contour programs and NC blocks
0: which are called in the following steps
unchanged are divided into individual movements
1: and stored in the contour table.
Calculation
forwards The number of relief cuts is returned.
and
backwards
Contour decoding
The blocks for a contour are stored in a
named table with one table line per
block and coded to save memory.
EXECUTE: Activate program
execution.
This switches back to normal program
execution from reference point editing
mode or after setting up a protection
zone.
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Fundamentals