Siemens SINUMERIK 840DE Programming Manual page 460

Tables
12.4 List of predefined subprograms
24. Tool management
1st parameter
DELT STRING[32]: Tool
designation
GETSELT VAR INT:
T number (return
value)
SETPIECE INT: Count
SETDNO INT: Tool number T INT: Tool
DZERO
DELDL INT: Tool number T INT: D No.
SETMTH INT: Tool-holder
no.
POSM INT: Location no.
for positioning
SETTIA VAR INT:
Status=result of
operation (return
value)
SETTA VAR INT:
Status=result of
operation (return
value)
RESETMON VAR INT:
Status=result of
operation (return
value)
#) The vocabulary word is not valid for SINUMERIK FM-NC.
12-54
2nd parameter 3rd
parameter
INT: Duplo
number
INT: Spindle
number
INT: Spindle
number
INT: D No.
edge no.
INT: No. of the INT:
magazine to Location
be moved number of
the internal
magazine
INT: Magazine INT: Wear
number grouping no.
INT: Magazine INT: Wear
number grouping no.
INT: Internal T INT: D no. of
no. tool
Explanation
Delete tool. Duplo number can be
omitted.
Get selected T number. If no spindle
number is specified, the command
for the master spindle applies.
Set number of workpieces for all
tools assigned to the spindle.
If the spindle number is omitted, the
command applies to the master
spindle.
Set D no. of tool (T) and its tool
edge to new
Set D numbers of all tools of the TO
unit assigned to the channel to
invalid
Delete all additive offsets of the tool
edge (or of a tool if D is not
specified)
Set toolholder no.
INT: Position magazine
Magazine
number of
the internal
magazine
Deactivate tool from wear group
Activate tool from wear group
Set actual value of tool to setpoint
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Fundamentals