Siemens SINUMERIK 840DE Programming Manual page 188

Path Action
5.2 Exact stop (G60, G9, G601, G602, G603)
Command outputs
In all three cases the following applies:
The auxiliary functions programmed in the NC block are enabled after the end of the
movement.
Machine manufacturer
Note
A machine data can be set for specific channels which determines that the default exact stop
criteria, which deviate from the programmed criteria, will be applied automatically. These are
given priority over the programmed criteria in some cases. Criteria for G0 and the other G
commands in the 1st G code group can be stored separately, see functional description FB1,
B1.
5-6
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Fundamentals