Working Area Limitation (G25/G26, Walimon, Walimof) - Siemens SINUMERIK 840DE Programming Manual
Hide thumbs
Also See for SINUMERIK 840DE:
- Operation & programming manual (233 pages) ,
- User manual (100 pages) ,
- Function manual (2184 pages)
Table of Contents
Advertisement
Positional Data
3.8 Working area limitation (G25/G26, WALIMON, WALIMOF)
Further information
The tool length components can be calculated according to the rotated working planes with
the functions for "Tool length compensation for orientable tools".
The offset plane is selected with CUT2D., CUT2DF. For further information on this and for
the description of the calculation possibility refer to the section "Tool offsets"
The control provides convenient coordinate transformation functions for the spatial definition
of the working plane.
For further information, please refer to Section "Coordinate system offset".
3.8
Working area limitation (G25/G26, WALIMON, WALIMOF)
Function
G25/G26 limits the working area, in which the tool can traverse in all channel axes. These
commands allow you to set up protection zones in the working area, which are out of bounds
for tool movements.
The working area limitation for all validated axes must be programmed with the WALMON
command. The WALIMOF command deactivates the working area limitation. WALIMON is
the default setting. Therefore, it only has to be programmed if working area limitation has
been disabled.
3-28
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Fundamentals
Advertisement
Table of Contents
