Siemens SINUMERIK 840DE Programming Manual page 461

25. Synchronous spindle
1st para-
meter
COUPDEF AXIS:
# Followin
g axis
COUPDEL # AXIS:
Followin
g axis
COUPRES AXIS:
# Followin
g axis
For synchronous spindles, the axis parameters are programmed with SPI(1) or S1.
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
2nd 3rd para- 4th para-
para- meter meter
meter
AXIS: REAL: REAL:
Leadin Counter Denomin
g axis transfor ator
mation transfor
ratio mation
ratio
(FA)
(LA)
AXIS:
Leadin
g axis
AXIS:
Leadin
g axis
5th parameter
STRING[8]: Block change behavior:
"NOC": no block change control,
block change is enabled
immediately, "FINE": block change
on "synchronism fine", "COARSE":
block change on synchronism
coarse and "IPOSTOP": block
change in setpoint-dependent
termination of overlaid movement. If
the block change behavior is not
specified, the set behavior is
applicable and there is no change.
12.4 List of predefined subprograms
6th
parameter
STRING[2]:
"DV":
Setpoint
coupling
"AV":
Actual-
value
coupling
Tables
Explanation
Couple
definition:
definition of
synchronized
spindle
grouping
Couple
delete:
Delete
synchronous
spindle
group
Couple reset:
Reset
synchronous
spindle
group.
The pro-
grammed
values
become
invalid. The
machine
data values
are valid.
12-55